Description

MULTI-ANGLE PHONE STAND by Natoshi Sakamoto << Tips are very welcome!

>> DOWNLOAD PDF <<

. 3x STL File(s)

Bounding Box Sizes

. 1x MultiAnglePhoneStand-Body = [X:69.497mm Y:14.993mm Z:14.998mm] [X:0’2 3/4″ Y:0’0 9/16″ Z:0’0 9/16″]

. 1x MultiAnglePhoneStand-Pin = [X:7.364mm Y:7.364mm Z:10.091mm] [X:0’0 5/16″ Y:0’0 5/16″ Z:0’0 3/8″ ]

. 1x MultiAnglePhoneStand-Spinner = [X:24.043mm Y:14.998mm Z:9.418mm] [X:0’0 15/16″ Y:0’0 9/16″ Z:0’0 3/8″]

. Rafts: No

. Supports: Yes

. Resolution: 0.16

. Infill: 15

. Filament Material: PLA

Notes

Support touching buildplate only. Support is needed for the keyring loop. Fine resolution (layer height lower than 1.6 mm) will end up with the pin too tight to fit in the spinner hole while Draft resolution (layer height above 1.6 mm).

Assembly

Insert the pin through the body and into spinner hole. The pin should be plug and play. Pressed in tightly into spinner hole.

If it is just too tight to be pressed, sand it a little with sandpaper or mini file. If it is too loose, heat the tip of the pin with a lighter (make the plastic soft) then press the tip gently on top of table or any flat surface so that the soft tip get wider. Leave it few seconds or a minute to hardened then try to fit in the spinner hole. Repeat until the pin bites well into the hole.

Check it out on Instructables : https://www.instructables.com/id/MAPS-Keychain/

THINIGIVERSE – MULTI ANGLE PHONE STAND by Chienline