Description
GLASSES CASE Remixed by Natoshi Sakamoto << Tips are very welcome!
This case is made of 4 pieces; 2 outer shells which have a hinge; 2 inner linings which can be printed in TPU for added protection. Using these will reduce the internal volume. It’s recommended a tight fit with your glasses so they do not rattle inside the case.
. 8x STL File(s)
Bounding Box Sizes
. 1x GlassesCaseSmall-OuterShell-01 = [X:149.00mm Y:72.50mm Z:16.79mm] [X:0’5 7/8″ Y:0’2 7/8″ Z:0’0 11/16″]
. 1x GlassesCaseSmall-InnerLinings-01 = [X:145.00mm Y:65.00mm Z:12.50mm] [X:0’5 11/16″ Y:0’2 9/16″ Z:0’0 1/2″]
. 1x GlassesCaseSmall-OuterShell-02 = [X:149.00mm Y:72.50mm Z:16.79mm] [X:0’5 7/8″ Y:0’2 7/8″ Z:0′ 11/16″]
. 1x GlassesCaseSmall-InnerLinings-02 = [X:145.00mm Y:65.00mm Z:12.50mm] [X:0’5 11/16″ Y:0’2 9/16″ Z:0’0 1/2″]
. 1x GlassesCaseMedium-OuterShell-01 = [X:158.94mm Y:72.50mm Z:26.79mm] [X:0’6 1/4″ Y:0’2 7/8″ Z:0’1 1/16″]
. 1x GlassesCaseMedium-InnerLinings-01 = [X:154.94mm Y:65.00mm Z:22.50mm] [X:0’6 1/8″ Y:0’2 9/16″ Z:0’0 7/8″]
. 1x GlassesCaseMedium-OuterShell-02 = [X:158.94mm Y:72.50mm Z:26.79mm] [X:0’6 1/4″ Y:0’2 7/8″ Z:0’1 1/6″]
. 1x GlassesCaseMedium-InnerLinings-02 = [X:154.94mm Y:65.00mm Z:22.50mm] [X:0’6 1/8″ Y:0’2 9/16″ Z:0’0 7/8″]
. Rafts: No
. Supports: No
. Resolution: 0.20
. Infill: 20%
. Filament Material: PLA for outer shells and TPU for inner Linings
Notes
Magnets required for the latch are 8mm Diameter x 2mm Thick, just glue them in with superglue.
Assembly
The hinge pin is just a length of 1.75mm filament, I recommend PETG but any stiff filament will work.
NatoshiSakamoto –
Awesome!